Park Tool Freewheel Remover FR-2C - Suntour 2 Pin

Fits older Sun Tour® two-notch freewheels
Two notches are approximately 25mm across measured outside to outside
Always use a skewer or axle nut to hold remover firmly in place

The FR-2 is designed to fit the two-notch tool fittings found on older SunTour® freewheels. Constructed from heat-treated alloy tool steel, the FR-2 features a 1" tool fitting for use with an adjustable wrench, socket, or bench vise.

FR-2 Features
Fits 2-notch tool fittings with an approximate outer diameter of 25 mm
Fits older SunTour® two-notch freewheels
Center bore for axle clearance is 10 mm
1" hexagonal base can be used with 1" socket or wrench
NOTE: SunTour® four-notch freewheels do not accept the FR-2 remover. Use the FR-3 for SunTour® freewheels with four notches.